Horiba Horiba LAQUAtwin Compact Meters

Always ensure the sensor is clean before calibrating.

If not, clean thoroughly with water (don’t worry, LAQUAtwin meters are completely waterproof!)

Place some standard solution on the sensor and press the calibration button. Once the smiley face appears indicating that calibration is complete, wash off the standard solution with water and dry with a clean, soft tissue.

LAQUAtwin meters only need a tiny amount of sample - so no beaker is necessary.

Fill the sensor with the sample and when the smiley face appears, the measurement is complete.

Clean the sensor thoroughly with water ready for the next test. When the sensor is nearing the end of its usable lifetime, it can be replaced;* you don’t need to replace the meter.

• *Sensors will need to be replaced after approx.
• *1500 measurements or when calibration cannot be completed. Sensors are sold separately and are easily removed and replaced

Immersion

• When you’re in the lab, you can test the sample in a beaker. Ensure the sensor guard sliding cap is open.

Scoop

• Use as a scoop to test water, for example from a river.

Drops

• LAQUAtwin meters can measure sample volumes as low as 0.05 mL*2. Place a drop of the sample onto the sensor with a pipette.
  • *2 Using the HORIBA sampling sheet, volumes down to 0.05 mL can be tested (except for conductivity measurements).

Solid samples

• Foods containing some moisture can be tested by placing a small piece directly onto the sensor.

Powders

• LAQUAtwin meters can also test dry powders.
• Simply place the powder sample onto the sensor, and drop on your defined volume of pure water.

Paper and textiles

• To test sheets of paper and textiles, cut up the sample into small pieces and place directly onto the sensor.
• Drop on your defined volume of pure water.

Calibrate and measure at the touch of a button — the smiley face will tell you when the result can be read.

Hassle-free automatic calibration with a few drops of standard solution reassures you of your measurement accuracy. Two-point calibration is also possible.*1

*1 Except for B-711

LAQUAtwin: the only meters with flat sensor technology.

HORIBA’s highly-sensitive, flat sensor technology opens up new possibilities for sampling and sample types. Only a small amount of sample is required, so you can easily sample in situ without the need for beakers or other labware.
Sensors are easily replaced as required.

Carry case comes as standard for handy portability.

The compact carry case contains everything you need for your measurements, including the standard solution and sampling sheets.

LAQUAtwin is IP67 rated.

The meter and sensor are fully waterproof*3 and dustproof, so you can take it anywhere.

*3 Will withstand immersion for 30 minutes at 1 m. Not suitable for underwater use.